4 Ways to Make a Doll House - wikiHow

This style is great for 30.48 cm (12 inch) dolls, like Barbies. The final product includes four rooms in a single level.

Visit a hardware store. You need a pair of wooden boards and a pair of tools to build this dollhouse. Tools are common tools that you most likely already have, but if you lack any tools, you can get them at any hardware store. The materials you need are: 4 x 1 x 8 '' boards (at least 60 cm long, or 24 inches), or a long board of 2.44 m (8 ft) if you plan to buy a single table.

4 12 '' x 12 '' agglomerate boards or similar material (you may need to go to an art store to find this material) 1/4 "drill A hand, table, or saw to make basic cuts on wood. 1/4" single or 8 pieces Sandpaper Wood glue Paint and other materials to create the finish / p>

Cut the wood. You should have 4 boards, but two will cut them even more. Meanwhile, cut the 4 boards into 60 cm (24 inch) pieces.

Drill the fixing points. Align the four pieces and, using a measuring tape and a pen, mark the holes at a height of 7 cm (3 inches) and 15 cm (6 inches) at each end along the 3/4 "strip at the sides (only one side should carry holes). Make sure all holes are properly aligned. Each table must have 4 marks. Drill a hole in the center on the side of each of the marks you made using a 1/4 "drill bit.

Join the boards. Put some wood glue and a peg in each of the holes in the boards of 60 cm (24 inches), one hole at a time. Allow the glue to dry and then place glue on the smaller boards. Mount the small boards onto the pins of the large boards, so that the edge is in the center of the large board. The result of this will be two wooden boards with a 3/4 inch (1.9 cm) slot in the middle of each half and a total width of 14 inches and 1/2 inches, . With a sandpaper, be sure to smooth the edges so they are smooth.

Now join the walls. These two wooden boards will fit into the central slot like two pieces of a puzzle, the slot will point upwards in a piece and down on the other. When joining them will form the walls of 4 rooms. This means that you can separate them when you need to keep the dollhouse or have to disarm it.

Adds the final details. Paint or use wallpaper to cover the walls, cut the area where the doors will go and add any other detail you want . Just remember not to paint or glue anything so that the two boards permanently.

More news: MORENAL PLANTS: Kalanchoe Pinnata (Yerba witch, leaf of the air, liberating) SUCULENTA MEDICINAL - Available in pot of cultivation N ° 12

rooms. Paint or give a finish to one side of each of the 4 pieces to match the rest of the room (whether room, bathroom, kitchen, etc). When it dries, arrange them as you want and then turn them and stick them on one side only.

  • So you can disarm and fold the dollhouse when you want to save it.

  • Adam Floyd